CAT 6015B Troubleshooting Hydraulic Mining Shovel
LWN 1-UP (Machine)
WSN 1-UP (Machine)
Type of machine: Hydraulic Mining Shovel
Print No: UENR5928-03 (en-us), February 2016
Language and Format: English/PDF
Instant Download after payment. Please make sure your email address is correct.
__________________
Table of contents:
Introduction
General Information
Service Tools
Connector Locations
Diagnostic Capabilities
Diagnostic Trouble Codes
Diagnostic Trouble Codes
Determining Diagnostic Trouble Codes
Event Codes
Event Codes
Symptom Troubleshooting
Symptom Troubleshooting
Emerging Symptom Information
Circuit Tests
CAN Data Link – Test
Charging System – Test
Electrical Connector – Inspect
Electrical Power Supply – Test
Emergency Stop – Test
Operator Control Switch (Switch to Ground)
Relay – Test
Sensor Signal (Analog, Active) – Test
Sensor Signal (Analog, Passive) – Test
Sensor Signal (PWM) – Test
Sensor Supply – Test
Solenoid Valve – Test
Switch Circuits – Test
Wiring Harness (Open Circuit) – Test
Wiring Harness (Short Circuit) – Test
Sensor Signal (Inductive) – Test
Service
ECM Software – Install
ECM – Configure
ECM – Replace
Connector Contact Description
System Schematic
Index Section
Index
About CAT 6015B Troubleshooting (Ver. February 2016) Documentation
This page provides technical documentation for the CAT 6015B Troubleshooting (Ver. February 2016) used by service technicians and maintenance professionals.
The technical manual typically includes troubleshooting procedures, adjustment instructions, service mode information, internal component layouts and maintenance guidelines required for proper repair and servicing.
These documents are commonly used in professional repair environments where accurate technical reference and correct service procedures are required.