Roland VersaCamm SP540V Service Manual and Parts List Manual

Service Manual and Parts List Manual Roland VersaCamm SP-540V;
This manual is in the PDF format and have detailed Diagrams, pictures and full procedures to diagnose and repair your Roland VersaCamm SP-540V plotter.
You can print, zoom or read any diagram, picture or page from this Service Manual and Parts List Manual. Every chapter on this manual is fully detailed and contain all the simulation codes, trouble codes, maintenance procedures, reset procedures, diagnose procedures of Roland VersaCamm SP-540V plotter. You can find easily everything what do you need.
To see what contain, please read table of contents:

1) Structure & Spare Parts
1-1 COVERS
1-2 FRAME2
1-3 DRIVE UNIT
1-4 HEAD CARRIAGE
1-5 BASE FRAME
1-6 CHASSIS
1-7 PINCH ROLL
1-8 STAY ROLL
1-9 TOOL CARRIAGE
1-10 WIPER SYSTEM
1-11 PUMP SYSTEM
1-12 INK SYSTEM
1-13 ACCESSORIES & STAND

2) Electrical Section
2-1 WIRING MAP
2-2 MAIN BOARD
2-3 SERVO BOARD
2-4 HEATER BOARD
2-5 SUB BOARD
2-6 MAINTENANCE PARTS LIST

3) Replacement of Main Parts
3-1 HEAD REPLACEMENT
3-2 WIPER REPLACEMENT
3-3 CAP TOP REPLACEMENT
3-4 TOOL CARRIAGE REPLACEMENT
3-5 CARRIAGE MOTOR REPLACEMENT
3-6 PUMP REPLACEMENT
3-7 INK TUBE REPLACEMENT
3-8 BATTERY REPLACEMENT
3-9 CARRIAGE WIRE REPLACEMENT
3-10 ENCODER SCALE REPLACEMENT
3-11 PINCH ROLELR REPLACEMENT
3-12 CUTTER PROTECTION REPLACEMENT
3-13 SW POWER SUPPLY REPLACEMENT
3-14 FLEXIBLE CABLE REPLACEMENT

4) Adjustment
4-1 SPECIAL TOOLS
4-2 SERVICE MODE
4-3 HOW TO UPGRADE FIRMWARE
4-4 HEAD ALIGNMENT
4-5 LMIT POSITION & CUT DOWN POSITION INITIALIZE
4-6 LINEAR ENCODER SETUP
4-7 CROP MARK SENSOR ADJUSTMENT
4-8 TOOL/CROP MARK SENSOR POSITION ADJUSTMENT
4-9 PRINT/CUT POSITION ADJUSTMENT
4-10 CALIBRATION (FEEDING DIRECTION)
4-11 TOOL HEIGHT ADJUSTMENT
4-12 TOOL PREASSURE ADJUSTMENT
4-13 CARRIAGE WIRE TENSION ADJUSTMENT
4-14 CAP HEIGHT ADJUSTMENT

5) Supplemental Information
SENSOR MAP

6) TROUBLESHOOTING
6-1 INK DROPS ON MEDIA / WHITE FINE LINE / BANDING /MISSING DOT / SCRATCHY PRINTING / BLURRED PRINTING
6-2 DOES NOT PRINT AT ALL
6-3 SHIFTING IN PRINTING
6-4 VERTICAL BANDING
6-5 PRINT DOES NOT MATCH WITH CUT
6-6 STITCH CUT
6-7 START AND END POINTS DO NOT MATCH
6-8 DISTORTED FIGURE
6-9 MEDIA SHIFTING
6-10 MOTOR ERROR
6-11 HEATER TEMPERATURE FAILS TO REACH THE PRESET VALUE
6-12 DOESN’T CONTROL THE THEMPERATURE
6-13 ERROR MESSAGE
6-14 SERVICE CALL

7) Service Activities
7-1 INSTALLATION CHECK LIST
7-2 MAINTENANCE CHECK LIST
7-3 SPECIFICATION