Roland SolJet Pro II V SJ-645EX SJ-745EX Service Manual

Service Manual Roland SolJet Pro II V SJ-645EX SJ-745EX;
This manual is in the PDF format and have detailed Diagrams, pictures and full procedures to diagnose and repair your Roland SolJet Pro II V.
You can print, zoom or read any diagram, picture or page from this Service Manual. Every chapter on this manual is fully detailed and contain all the simulation codes, trouble codes, maintenance procedures, reset procedures, diagnose procedures of Roland SolJet Pro II V SJ-645EX SJ-745EX. You can find easily everything what do you need.
To see what contain, please read table of contents:

1) Structure & Spare Parts
1-1 COVERS
1-2 FRAME
1-3 CARRIAGE
1-4 DRIVE UNIT
1-5 CHASSIS
1-6 PINCH ROLLER
1-7 STAY ROLL
1-8 WIPER SYSTEM
1-9 PUMP SYSTEM
1-10 INK SYSTEM
1-11 BASE FRAME
1-12 ACCESSORIES & STAND
1-13 TUC-1 CONTROLLER
1-14 TUC-1 OTHERS
1-15 TUC-1 ACCESSORIES
1-16 TU-750/650/550

2) Electrical Section
2-1 WIRING MAP
2-2 MAIN BOARD
2-3 HEAD / SERVO BOARD
2-4 SUB BOARD
2-5 TUC-1
2-6 HEATER BOARD
2-6 MAINTENANCE PARTS LIST

3) Replacement of Main Parts
3-1 HEAD REPLACEMENT
3-2 WIPER REPLACEMENT
3-3 CAP TOP REPLACEMENT
3-4 CARRIAGE MOTOR REPLACEMENT
3-5 PUMP REPLACEMENT
3-6 INK TUBE REPLACEMENT
3-7 BOARDS REPLACEMENT
3-8 BATTERY REPLACEMENT
3-9 CARRIAGE WIRE REPLACEMENT
3-10 ENCODER SCALE REPLACEMENT

4) Adjustment
4-1 Special Tools
4-2 SERVICE MODE
4-3 HOW TO UPGRADE FIRMWARE
4-4 HEAD ALIGNMENT
4-5 CAP HEIGHT ADJUSTMENT
4-6 LINEAR ENCODER SETUP
4-7 LIMIT POSITION & CUT DOWN POSITION INITIALIZE
4-8 PAPER SIDE SENSOR ADJUSTMENT
4-9 CALIBRATION (FEEDING DIRECTION)
4-10 CARRIAGE WIRE TENSION ADJUSTMENT
4-11 NETWORK BOARD INITIALIZE
4-12 OPERATION OF THE HEATER CONTROLLER
4-13 SETTING THE PARAMETER OF THE HEATER CONTROLLER

5) Supplemental Information
5-1 SENSOR MAP

6) Troubleshooting
6-1 WHITE FINE LINES / BANDING / MISSING DOT / SCRATCHY
PRINTING / BLURRED PRINTING
6-2 IT DOESN’T PRINT AT ALL
6-3 INK DROPS ON MEDIA
6-4 SHIFTING IN PRINTING
6-5 VERTICAL BANDING
6-6 MEDIA SHIFTING
6-7 MOTOR ERROR
6-8 ERROR MESSAGE
SERVICE CALL
6-9 HEATER TEMPERATURE FAILS TO REACH THE PRESET VALUE
6-10 RESULTS OF PRINTING ARE COARSE
6-11 ERROR MESSAGE (HEATER CONTROLLER)

7) Service Activities
7-1 INSTALLATION CHECK LIST
7-2 MAINTENANCE CHECK LIST
7-3 Specifi cation

Number of pages: 191.