Roland VersaArt RS-640 VersaArt RS-540 Service Manual and Parts List Manual

Service Manual and Parts List Manual Roland VersaArt RS-640 VersaArt RS-540;
This manual is in the PDF format and have detailed Diagrams, pictures and full procedures to diagnose and repair your Roland VersaArt.
You can print, zoom or read any diagram, picture or page from this Service Manual and Parts List Manual. Every chapter on this manual is fully detailed and contain all the simulation codes, trouble codes, maintenance procedures, reset procedures, diagnose procedures of Roland VersaArt RS-640 VersaArt RS-540. You can find easily everything what do you need.
To see what contain, please read table of contents:

1) Structure & Spare Parts
1-1 COVERS
1-2 FRAME
1-3 DRIVE UNIT
1-4 HEAD CARRIAGE
1-5 BASE FRAME
1-6 CHASSIS
1-7 PINCH ROLLER
1-8 STAND
1-9 WIPER SYSTEM
1-10 PUMP SYSTEM
1-11 INK SYSTEM
1-12 ACCESSORIES

2) Electrical Section
2-1 WIRING MAP
2-2 MAIN BOARD
2-3 SERVO BOARD
2-4 CARRAGE BOARD
2-5 SUB BOARD
2-6 MAINTENANCE PARTS LIST

3) Replacement of Main Parts
3-1 HEAD REPLACEMENT
3-2 WIPER REPLACEMENT
3-3 CAP TOP REPLACEMENT
3-4 CARRIAGE MOTOR REPLACEMENT
3-5 FEED MOTOR REPLACEMENT
3-6 PUMP REPLACEMENT
3-7 INK TUBE REPLACEMENT
3-8 BOARD REPLACEMENT (MAIN BOARD SW POWER SUPPLY)
3-9 BATTERY REPLACEMENT
3-10 CARRIAGE BELT REPLACEMENT
3-11 ENCODER SCALE REPLACEMENT
3-12 GRIT ENCODER REPLACEMENT
3-13 PINCH ROLLER REPLACEMENT
3-14 HOLDER CABLE SHEET REPLACEMENT

4) Adjustment
4-1 SERVICE MODE
4-2 HOW TO UPGRADE FIRMWARE/INSTALL FIRMWARE
4-3 HOW TO UPGRADE FIRMWARE OF THE NETWORK CONTROLLER
4-4 HEAD ALIGNMENT
4-5 LIMIT POSITION & CUT DOWN POSITION INITIALIZE
4-6 LINEAR ENCODER SETUP
4-7 FLUSHING POSITION ADJUSTMENT
4-8 CALIBRATION(FEEDING DIRECTION)
4-9 BELT TENSION ADJUSTMENT
4-10 BELT POSITION ADJUSTMENT
4-11 TAKE-UP UNIT OPERATION CHECK
4-12 PAPER SIDE SENSOR ADJUSTMENT

5) Supplemental Information
5-1 SPECIAL TOOLS
5-2 SENSOR MAP

6) Troubleshooting
6-1 DEFECT OF PRINT QUALITY (BANDING/SCRATCHY PRINTING/BLURRED PRINTING)
6-2 PARTICULAR COLOR IS NOT PRINTED AT ALL
6-3 SHIFTING IN PRINTING / COLOR SHIFTING
6-4 INK DROPS ON THE MEDIA
6-5 VERTICAL BANDING
6-6 MISSING DOT OR DEFLECTED-FIRED DOT APPEARS WHEN PERFORMING PRINTING WITH LONG DELAY
6-7 MEDIA SKEW
6-8 MOTOR ERROR
6-9 HEATER/DRYER TEMPERATURE DOES NOT GO UP
6-10 PROBLEM IN NETWORK(RIP DOES NOT RECOGNIZE THE PRINTER)
6-11 ERROR MESSAGE
6-12 SERVICE CALL

7) Service Activities
7-1 INSTALLATION CHECK LIST
7-2 MAINTENANCE CHECK LIST
7-3 SPECIFICATION